Updated Nov 16, 2026· 7 min read

Key takeaways

  • Opening the PSU. Internal capacitors can hold a dangerous charge after the unit is unplugged, and opening the case normally voids the warranty.
  • Assuming every click is a failure. Relays and fan start-up behaviour can be normal.
  • Ignoring a repeating click paired with instability. Shutdowns, restarts or a burning smell warrant immediate attention.
  • Blaming the PSU for GPU or drive noise. Isolate the source before replacing parts.
  • Spraying compressed air into a spinning fan. Hold the blades still or keep the burst short and distant.
  • Running a PSU with a failing fan. Heat reduces the lifespan of the unit and the components it powers.

A clicking noise from a PC power supply is most often a fan problem, such as a loose cable touching the blades, dust, or a worn bearing, but it can also be a harmless relay click at power-on, or a sound that actually comes from a hard drive or graphics card. Switch the PC off and unplug it from the wall before investigating, never open the power supply case, and contact the maker if the noise comes with shutdowns, a burning smell or visible damage.

Quick Reference: Symptom, Likely Cause, What to Do

What you hear Common cause First step
Single click when you flip the PSU switch or when the PC starts Internal relay or inrush-control circuit engaging, which some units do by design Usually normal if the PC runs fine; ask the maker if it is new behaviour
Rapid tick that follows fan speed A cable or zip-tie touching the fan blades, or debris in the fan Power down, unplug, re-route cables away from the PSU intake and exhaust
Ticking or grinding that grows louder over weeks Worn fan bearing Contact the maker for warranty service; do not open the unit
Click each time the fan starts or stops Zero-RPM or semi-passive mode cycling at low load Check the manual for fan-mode behaviour and any fan-mode switch
Buzzing or high-pitched chirp under load Coil whine, which is a vibration noise rather than a click Compare with the GPU; try a frame-rate cap to see if it changes
Click with a clunk from the case Hard drive head noise, or a case panel vibrating Locate the source by powering down and checking each device

Step One: Confirm the Noise Is Really the PSU

Power supplies sit at the bottom or top of the case, but their sound travels through the chassis, so it is easy to misjudge the origin. Graphics-card fans, case fans, a spinning hard drive and loose side panels are all frequent sources of a click that gets blamed on the PSU.

  1. Shut down and unplug the PC. Wait a few moments, and touch bare metal on the case to discharge static before reaching inside.
  2. Check that no cables rest against the PSU fan opening, which is visible at the rear grille or on the underside if the PSU draws air from below.
  3. Look for loose screws, drive trays or cable ties that could rattle against the case.
  4. If your drives are spinning disks, note whether the clicking pattern changes during file access rather than with fan speed. A drive with an irregular clicking pattern may be failing, so back up important data and check the drive maker’s diagnostic tools.
  5. Reconnect and power up. A sound that follows fan speed points toward a fan, while one that follows disk access points toward a drive.

Cause 1: Something Touching the Fan

A fan blade striking a cable or a bit of packaging creates a rhythmic tick that speeds up as the fan accelerates. This is a cheap fix when the obstruction is outside the PSU: re-route cables, remove loose zip-tie tails, and make sure dust filters and cable shrouds are not rubbing the grille. If the obstruction sits inside the power supply, leave it to the maker, since the housing contains components that can hold a charge after the unit is unplugged.

Cause 2: Dust and Debris

Dust builds up on the intake and fan blades, especially in cases without filters, and can unbalance a blade or catch on the grille. Clean the exterior of the PSU grille with a soft brush while the system is unplugged and powered down. Use short bursts of compressed air from a distance and keep the fan from free-spinning rapidly, because a fan driven by an air stream can generate voltage and be damaged. Never insert tools into the vent opening.

Cause 3: A Worn Fan Bearing

A fan that develops a ticking, clicking or grinding sound over time, particularly one that is louder at start-up and improves as the fan warms, may have a worn bearing. Fan bearings are mechanical parts, and different bearing types age differently. Fluid dynamic and ball bearing designs generally last longer than basic sleeve bearings, according to commonly cited fan-maker documentation, although the exact lifespan depends on the model, temperature and dust.

If the supply is within its warranty, contact the maker. Replacing a PSU fan yourself is not advisable because it normally requires opening the case, which exposes dangerous internal voltages and typically voids the warranty. A power supply with a failing fan that cannot cool the unit is a risk, so replace it rather than letting it run hot.

Cause 4: Fan Mode Switching

Many modern power supplies use a semi-passive or zero-RPM mode in which the fan stays off at low load and spins up when temperature or load rises. Some users hear a faint click or tick as the fan starts or stops. This can be normal behaviour. The maker’s manual explains the fan curve and whether the unit has a switch or a utility that changes the mode. If a fan starts and stops rapidly at light loads, a different mode or a different case airflow setup can reduce the cycling, within what the maker supports.

Cause 5: Relay Click at Power-On

Some power supplies contain a relay that engages after the capacitors charge. It can produce a single audible click when you flip the rear switch or when the PC powers on, and it is part of the supply’s start-up design rather than a defect. A single click at start-up with a stable system afterward is normally not a concern. Repeating clicks, a click followed by no power, or a click that appears with random shutdowns should be treated differently, and the maker or a technician should assess the unit.

Clicking Versus Coil Whine

Coil whine is a high-pitched buzz or whine produced when electrical components vibrate, and it is often heard under load or at certain frame rates. It can come from the graphics card, the motherboard VRMs or the PSU. It is not a click and is generally not a safety problem, although it can be annoying. If you suspect the PSU, a different unit in the same system, or the same card in a different system, helps isolate it. Reviewers frequently note that coil whine varies between samples of the same model.

Decision Table: What to Do Next

Situation Reasonable action
Single click at power-on, system stable Likely normal start-up behaviour; check the manual if unsure
Tick that matches fan speed, cables near the fan Power down, unplug, move the cables, retest
Dusty grille or filter Clean the exterior carefully, unplugged, and restore filters
Grinding or ticking from the fan after months of use Contact the maker about warranty or replacement
Click plus random shutdowns, burning smell or visible damage Stop using the PSU and contact the maker or a technician
Clicking tied to disk activity Back up data and test the drive with its maker’s utility

Common Mistakes

  • Opening the PSU. Internal capacitors can hold a dangerous charge after the unit is unplugged, and opening the case normally voids the warranty.
  • Assuming every click is a failure. Relays and fan start-up behaviour can be normal.
  • Ignoring a repeating click paired with instability. Shutdowns, restarts or a burning smell warrant immediate attention.
  • Blaming the PSU for GPU or drive noise. Isolate the source before replacing parts.
  • Spraying compressed air into a spinning fan. Hold the blades still or keep the burst short and distant.
  • Running a PSU with a failing fan. Heat reduces the lifespan of the unit and the components it powers.

When to Contact the Maker or a Technician

Reach out when the noise changes quickly, the PC shuts down under load, you smell burning, or the unit is still under warranty and the sound persists after a clean and cable check. Keep the model and serial number ready. A professional can test the supply with proper equipment, which is safer than guessing with a multimeter inside a PC.

Frequently Asked Questions

Is a clicking power supply dangerous?

Not always. A single click at power-on or a fan start tick can be normal, but a repeating click with shutdowns, heat or a burning smell is a sign to stop using the unit. When in doubt, unplug it and contact the maker.

Can I oil or replace the PSU fan myself?

This normally requires opening the power supply, which exposes internal voltages and typically voids the warranty. Contact the maker for service or replace the whole unit.

Why does the click happen only when the fan starts?

Semi-passive designs keep the fan off at low load and start it when temperatures rise, so you may hear the fan beginning to move. If the click is loud or repeats rapidly, ask the maker about the fan-mode behaviour for your model.

Could the clicking come from my hard drive?

Yes. A mechanical drive with an irregular click, especially during access, may be developing a fault. Back up your data and test the drive with the drive maker’s tool.

Is coil whine the same as clicking?

No. Coil whine is a buzz or high-pitched tone caused by vibrating components, while clicking is a short mechanical sound. Coil whine varies between samples and is usually not a safety issue.

L
Liam Bennett
We compare specs, materials and verified owner reviews before a product earns a spot. Rankings are never paid.

FAQ

Is a clicking power supply dangerous?
Not always. A single click at power-on or a fan start tick can be normal, but a repeating click with shutdowns, heat or a burning smell is a sign to stop using the unit. When in doubt, unplug it and contact the maker.
Can I oil or replace the PSU fan myself?
This normally requires opening the power supply, which exposes internal voltages and typically voids the warranty. Contact the maker for service or replace the whole unit.
Why does the click happen only when the fan starts?
Semi-passive designs keep the fan off at low load and start it when temperatures rise, so you may hear the fan beginning to move. If the click is loud or repeats rapidly, ask the maker about the fan-mode behaviour for your model.
Could the clicking come from my hard drive?
Yes. A mechanical drive with an irregular click, especially during access, may be developing a fault. Back up your data and test the drive with the drive maker’s tool.
Is coil whine the same as clicking?
No. Coil whine is a buzz or high-pitched tone caused by vibrating components, while clicking is a short mechanical sound. Coil whine varies between samples and is usually not a safety issue.
Affiliate disclosure. As an Amazon Associate we earn from qualifying purchases at no extra cost to you. Prices accurate as of the date shown.

More from Amazon

Programs that pair well with the guide above. Offers and eligibility are set by Amazon and may change.

Amazon Prime

Free shipping on eligible items, Prime Video and more. Eligible new members can start with a free trial.

Start a Prime free trial
Amazon Music Unlimited

Ad-free music streaming. Eligible new subscribers can start with a free trial.

Try Music Unlimited free
Prime for Young Adults

A Prime membership for ages 18-24 with a trial period. Eligibility is set by Amazon.

See Prime for Young Adults
Audible

Audiobooks and podcasts to listen to on the go. Eligible new members can start with a free trial.

Try Audible free

As an Amazon Associate we earn from qualifying purchases.